90MM M2000 WIDE SLOT TAKE-UP EXPANSION WITH GARTER SEALS

The 90 mm M2000 Wide Slot Take-up Expansion Bearing with Garter Seals is Moline Bearing Company part 19151090G: a mounted spherical roller bearing in the expansion position. It is fitted with a spring loaded garter seal and a single collar, set screw locking insert, in a solid Class 30 cast iron housing with a standard painted finish.

It carries a genuine SKF or Timken spherical roller insert, which gives it high load capacity and the most misalignment tolerance of Moline's lines. M2000 housings are made in the USA, and the units are assembled here.

It ships assembled, adjusted, sealed and pre-lubricated with lithium complex grease, so it mounts straight from the box with no adjustment or cleaning.

Ratings

The dynamic load rating is 56,900 lbf and the static load rating is 76,400 lbf. Maximum speed is 800 rpm with the spring loaded garter seal fitted, and the seal is rated for 0° to 250°F. The insert accepts up to 1.5° of angular misalignment. Set screws torque to 1,325 in-lbs, and the locking system holds 6,800 lbf of radial load before the insert slips on the shaft. The grease fitting is 1/8-27 NPT.

Mounting dimensions

• Slot width: 1 25⁄32 in
• Slot length: 6 in
• Travel rod diameter: 1 3⁄4 in
• Housing length: 10 1⁄4 in
• Housing width: 3 5⁄8 in
• Shaft centerline to end of tail: 6 3⁄8 in
• Length through bore: 4 1⁄32 in
• Shipping weight: 38 lb

The full dimension table and the datasheet drawing are above.

This configuration

• Expansion. This position lets the shaft move lengthwise as it heats and grows. Pair it with a non-expansion bearing at the other end. The matching non-expansion unit for this shaft size is 19251090G.
• Spring Loaded Garter Seal. A contact seal with a garter spring keeping constant lip pressure on the shaft, holding its seal as the lip wears.
• Single Collar. One locking collar secures the insert to the shaft. Standard for unidirectional rotation and steady loads.
• Set Screw Locking. Set screws in the collar bite into the shaft. Simple and widely used; best where rotation is in one direction.

The same size is also built as 19151090 (triple-lip contact seals), 19151090L (labyrinth seals), 19151090D (double collar, triple-lip contact seals), 19151090DG (double collar), 19151090DL (double collar, labyrinth seals).

Replacement parts

The bearing insert is SLA18-090.

Applications

M2000 units are the choice where a high-capacity, self-aligning bearing is needed and shaft expansion or misalignment is expected. Moline Bearing Company lists conveying, screening, air handling, paper and forestry, and food processing among the industries that run them. It is directly interchangeable with other collar-mounted spherical roller bearings in single-piece housings, including Moline's M3000 line.