85MM M2000 WIDE SLOT TAKE-UP NON-EXPANSION WITH DOUBLE COLLAR INSERT
The 85 mm M2000 Wide Slot Take-up Non-Expansion Bearing with Double Collar Insert is Moline Bearing Company part 19251085D: a mounted spherical roller bearing in the non-expansion position. It is fitted with a standard triple lip contact seal and a double collar, set screw locking insert, in a solid Class 30 cast iron housing with a standard painted finish.
It carries a genuine SKF or Timken spherical roller insert, which gives it high load capacity and the most misalignment tolerance of Moline's lines. M2000 housings are made in the USA, and the units are assembled here.
It ships assembled, adjusted, sealed and pre-lubricated with lithium complex grease, so it mounts straight from the box with no adjustment or cleaning.
Ratings
The dynamic load rating is 56,900 lbf and the static load rating is 76,400 lbf. Maximum speed is 1,300 rpm with the standard triple lip contact seal fitted, and the seal is rated for 0° to 250°F. The insert accepts up to 1.5° of angular misalignment. Set screws torque to 1,325 in-lbs, and the locking system holds 6,800 lbf of radial load before the insert slips on the shaft. The grease fitting is 1/8-27 NPT.
Mounting dimensions
- Slot width: 1 25⁄32 in
- Slot length: 6 in
- Travel rod diameter: 1 3⁄4 in
- Housing length: 10 1⁄4 in
- Housing width: 3 5⁄8 in
- Shaft centerline to end of tail: 6 3⁄8 in
- Length through bore: 5 3⁄16 in
- Shipping weight: 38 lb
The full dimension table and the datasheet drawing are above.
This configuration
- Non-Expansion. This position holds the shaft axially. Use one non-expansion bearing per shaft to locate it lengthwise. The matching expansion unit for this shaft size is 19151085D.
- Standard Triple Lip Contact Seal. Three lips in series for demanding contamination exclusion, at the cost of more running friction and heat.
- Double Collar. Two locking collars share the clamping load, improving holding power under reversing rotation or shock.
- Set Screw Locking. Set screws in the collar bite into the shaft. Simple and widely used; best where rotation is in one direction.
The same size is also built as 19251085 (single collar), 19251085G (single collar, garter seals), 19251085L (single collar, labyrinth seals), 19251085DG (garter seals), 19251085DL (labyrinth seals).
Replacement parts
The bearing insert is SLA18-085.
Applications
M2000 units are the choice where a high-capacity, self-aligning bearing is needed and shaft expansion or misalignment is expected. Moline Bearing Company lists conveying, screening, air handling, paper and forestry, and food processing among the industries that run them. It is directly interchangeable with other collar-mounted spherical roller bearings in single-piece housings, including Moline's M3000 line.