50MM M2000 2-BOLT PILLOW BLOCK NON-EXPANSION

The 50 mm M2000 2-Bolt Pillow Block Non-Expansion Bearing is Moline Bearing Company part 19221050: a mounted spherical roller bearing in the non-expansion position. It is fitted with a standard triple lip contact seal and a single collar, set screw locking insert, in a solid Class 30 cast iron housing with a standard painted finish.

It carries a genuine SKF or Timken spherical roller insert, which gives it high load capacity and the most misalignment tolerance of Moline's lines. M2000 housings are made in the USA, and the units are assembled here.

It ships assembled, adjusted, sealed and pre-lubricated with lithium complex grease, so it mounts straight from the box with no adjustment or cleaning.

Ratings

The dynamic load rating is 19,000 lbf and the static load rating is 22,500 lbf. Maximum speed is 2,400 rpm with the standard triple lip contact seal fitted, and the seal is rated for 0° to 250°F. The insert accepts up to 1.5° of angular misalignment. Set screws torque to 290 in-lbs, and the locking system holds 2,300 lbf of radial load before the insert slips on the shaft. The grease fitting is 1/8-27 NPT.

Mounting dimensions

• Base to center height: 2 1⁄4 in
• Bolt hole centers: 6 1⁄4 in (slots allow 5 15⁄16 to 6 9⁄16 in), for 5⁄8 in bolts
• Housing base: 8 3⁄8 × 2 3⁄16 in
• Overall height: 4 9⁄16 in
• Length through bore: 2 7⁄8 in
• Overall unit width: 3 in
• Shipping weight: 9.1 lb

The full dimension table and the datasheet drawing are above.

This configuration

• Non-Expansion. This position holds the shaft axially. Use one non-expansion bearing per shaft to locate it lengthwise. The matching expansion unit for this shaft size is 19121050.
• Standard Triple Lip Contact Seal. Three lips in series for demanding contamination exclusion, at the cost of more running friction and heat.
• Single Collar. One locking collar secures the insert to the shaft. Standard for unidirectional rotation and steady loads.
• Set Screw Locking. Set screws in the collar bite into the shaft. Simple and widely used; best where rotation is in one direction.

The same size is also built as 19221050L (labyrinth seals), 19221050DG (double collar, garter seals), 19221050DL (double collar, labyrinth seals), 19221050D (double collar), 19221050G (garter seals).

Replacement parts

The bearing insert is SLA10-050, and the housing on its own is Moline Bearing Company part 11221115.

Applications

M2000 units are the choice where a high-capacity, self-aligning bearing is needed and shaft expansion or misalignment is expected. Moline Bearing Company lists conveying, screening, air handling, paper and forestry, and food processing among the industries that run them. It is directly interchangeable with other collar-mounted spherical roller bearings in single-piece housings, including Moline's M3000 line.