60MM SPLIT E1000 2-BOLT PILLOW BLOCK EXPANSION WITH SINGLE COLLAR INSERT

The 60 mm Split E1000 2-Bolt Pillow Block Expansion Bearing with Single Collar Insert is Moline Bearing Company part 39322060A: a split-housing mounted tapered roller bearing in the expansion position. It is fitted with a standard V-Guard contact seal and a single collar, set screw locking insert, in a split 65-45-12 ductile iron housing with a standard painted finish.

It carries a genuine Timken® Enhanced DEE tapered roller insert in a replaceable solid cartridge, so the bearing can be swapped without removing or replacing the housing. The housing is 65-45-12 ductile iron, split so it can be fitted around a shaft in place. Split E1000 units are made, machined and assembled in the USA.

It ships assembled, adjusted, sealed and pre-lubricated with lithium complex grease, so it mounts straight from the box with no adjustment or cleaning.

Ratings

The dynamic load rating is 11,600 lbf and the static load rating is 54,000 lbf. Maximum speed is 2,100 rpm with the standard V-Guard contact seal fitted, and the seal is rated for 0° to 250°F. The insert accepts up to 4° of angular misalignment. Set screws torque to 290 in-lbs, and the locking system holds 9,500 lbf of radial load before the insert slips on the shaft. The grease fitting is 1/8-27 NPT.

Mounting dimensions

• Base to center height: 2.75 in
• Bolt hole centers: 7 13⁄16 in (slots allow 6 15⁄16 to 8 11⁄16 in), for 5⁄8 in bolts
• Housing base: 10 3⁄8 × 3 in
• Overall height: 6 in
• Length through bore: 4 in
• Shipping weight: 24 lb

The full dimension table and the datasheet drawing are above.

This configuration

• Expansion. This position lets the shaft move lengthwise as it heats and grows. Pair it with a non-expansion bearing at the other end. The matching non-expansion unit for this shaft size is 49322060A.
• Standard V-Guard Contact Seal. Moline's standard contact seal, with a lip riding on the insert to exclude contamination.
• Single Collar. One locking collar secures the insert to the shaft. Standard for unidirectional rotation and steady loads.
• Set Screw Locking. Set screws in the collar bite into the shaft. Simple and widely used; best where rotation is in one direction.

The same size is also built as 39322060 (double collar), 39322060L (double collar, labyrinth seals), 39322060AL (labyrinth seals).

Replacement parts

The bearing insert is NPE39236DEE-401C4. Closed end cap 18620207 fits this housing.

Applications

The split housing is for shafts that cannot be dismantled to feed a solid bearing on, in the same high radial and thrust load service as Type E: conveying, screening, cranes, mining, forestry, oil, gas, power generation and aggregate. It is dimensionally interchangeable with comparable Type E units, including Moline's Type E, ME2000 and ME3000 lines.