1-3/4 TYPE E WIDE SLOT TAKE-UP WITH SINGLE COLLAR INSERT & LABYRINTH SEALS

The 1 3⁄4" Type E Wide Slot Take-up Non-Expansion Bearing with Single Collar Insert and Labyrinth Seals is Moline Bearing Company part 19351112AL: a mounted tapered roller bearing in the non-expansion position. It is fitted with a balanced steel and Teflon labyrinth seal and a single collar, set screw locking insert, in a solid Class 30 cast iron housing with a standard painted finish.

It carries a genuine Timken® Enhanced DEE tapered roller insert: case-hardened rollers and races made from vacuum-degassed steel, with a double-extended inner race, rated for high radial and thrust loads and slight angular misalignment. The housing is machined to close tolerances, and the unit is made, machined and assembled in the USA.

It ships assembled, adjusted, sealed and pre-lubricated with lithium complex grease, so it mounts straight from the box with no adjustment or cleaning.

Ratings

The dynamic load rating is 7,860 lbf and the static load rating is 33,000 lbf. Maximum speed is 3,050 rpm with the balanced steel and Teflon labyrinth seal fitted, and the seal is rated for 0° to 350°F. The insert accepts up to 0.05° of angular misalignment. Set screws torque to 165 in-lbs, and the locking system holds 6,400 lbf of radial load before the insert slips on the shaft. The grease fitting is 1/8-27 NPT.

Mounting dimensions

• Slot width: 11⁄16 in
• Slot length: 3 3⁄4 in
• Travel rod diameter: 1 in
• Housing length: 6 5⁄16 in
• Housing width: 2 7⁄16 in
• Shaft centerline to end of tail: 3 15⁄16 in
• Length through bore: 3 1⁄2 in
• Shipping weight: 12 lb

The full dimension table and the datasheet drawing are above.

This configuration

• Non-Expansion. This position holds the shaft axially. Use one non-expansion bearing per shaft to locate it lengthwise.
• Balanced Steel and Teflon Labyrinth Seal. A labyrinth seal combining steel with a Teflon element, adding chemical resistance and a wider temperature range to a non-contact design.
• Single Collar. One locking collar secures the insert to the shaft. Standard for unidirectional rotation and steady loads.
• Set Screw Locking. Set screws in the collar bite into the shaft. Simple and widely used; best where rotation is in one direction.

The same size is also built as 19351112L (double collar), 19351112 (double collar, standard V-Guard contact seal), 19351112A (standard V-Guard contact seal).

Replacement parts

The bearing insert is 365DE or NPE365DEE-401C4. Open end cap 18601112 and closed end cap 18620115 fit this housing.

Applications

Type E units are specified where radial loads, thrust loads or both are high and misalignment is minimal. Moline Bearing Company lists conveying, screening, cranes, mining, forestry, oil, gas, power generation and aggregate among the industries that run them. It is dimensionally interchangeable with comparable Type E units, including Moline's Split E1000, ME2000 and ME3000 lines.