100MM TYPE E 4-BOLT FLANGE WITH LABYRINTH SEALS

The 100 mm Type E 4-Bolt Flange Non-Expansion Bearing with Labyrinth Seals is Moline Bearing Company part 19311100L: a mounted tapered roller bearing in the non-expansion position. It is fitted with a balanced steel and Teflon labyrinth seal and a double collar, set screw locking insert, in a solid Class 30 cast iron housing with a standard painted finish.

It carries a genuine Timken® Enhanced DEE tapered roller insert: case-hardened rollers and races made from vacuum-degassed steel, with a double-extended inner race, rated for high radial and thrust loads and slight angular misalignment. The housing is machined to close tolerances, and the unit is made, machined and assembled in the USA.

It ships assembled, adjusted, sealed and pre-lubricated with lithium complex grease, so it mounts straight from the box with no adjustment or cleaning.

Ratings

The dynamic load rating is 26,900 lbf and the static load rating is 154,000 lbf. Maximum speed is 1,530 rpm with the balanced steel and Teflon labyrinth seal fitted, and the seal is rated for 0° to 350°F. The insert accepts up to 0.05° of angular misalignment. Set screws torque to 1,325 in-lbs, and the locking system holds 22,000 lbf of radial load before the insert slips on the shaft. The grease fitting is 1/8-27 NPT.

Mounting dimensions

• Bolt hole centers: 7 3⁄4 in
• Bolt size: 7⁄8 in
• Flange: 10 1⁄4 × 10 1⁄4 in
• Length through bore: 6 1⁄4 in
• Shipping weight: 74 lb

The full dimension table and the datasheet drawing are above.

This configuration

• Non-Expansion. This position holds the shaft axially. Use one non-expansion bearing per shaft to locate it lengthwise.
• Balanced Steel and Teflon Labyrinth Seal. A labyrinth seal combining steel with a Teflon element, adding chemical resistance and a wider temperature range to a non-contact design.
• Double Collar. Two locking collars share the clamping load, improving holding power under reversing rotation or shock.
• Set Screw Locking. Set screws in the collar bite into the shaft. Simple and widely used; best where rotation is in one direction.

The same size is also built as 19311100 (standard V-Guard contact seal).

Replacement parts

The bearing insert is NPE52392DEE-401C4. Open end cap 18601315 and closed end cap 18600315 fit this housing.

Applications

Type E units are specified where radial loads, thrust loads or both are high and misalignment is minimal. Moline Bearing Company lists conveying, screening, cranes, mining, forestry, oil, gas, power generation and aggregate among the industries that run them. It is dimensionally interchangeable with comparable Type E units, including Moline's Split E1000, ME2000 and ME3000 lines.